Nvidia GTX Titan X – External Power Guide

6. Hook up the power board

Now it’s time to attach the power board to your card. Make sure you use as much ground and vGPU as possible. The more – the better. I used 0.5 mm copper sheets to connect everything.

I marked some Ground spots on the front which are quite good to use. You can also use all mounting holes on the back of the card.

gnd

 

IMG_7091 IMG_7092 IMG_7093

Afterwards re-check the resistance between vGPU and Ground. The resistance should stay at about the same level as before. Again, if you have a resistance below 1 ohm recheck everything and don’t power up the card. Otherwise you might damage something.

638,248 total views, 9 views today

30 comments

Leave a Reply

Your email address will not be published. Required fields are marked *